CleanAll Heavy
CLEANALL HEAVY is the new generation dispersant that approved from EEAA AS OIL SPILL DISPERSANT . It can be used concentrated or diluted to a ratio of 1 : 9 depending on contamination l*evel. It is an efficient, environmental friendly product and biodegradable.
CLEANALL HEAVY has been specifically designed for oil dispersion at sea, at shore and in port, either on-or-off board.
* ADVANTAGES AND CHARACTERISTIC:
ü Non toxic to marine life.
ü Converts oil spills to hydrophilic droplets that are easily biodegradable.
ü The dispersion of oil spill is horizontally not vertically, not enter in the water column , So it will float on the sea surface as a very small particles exposed to the daily sun light so that the photo oxidation will increase also the temperature on the sea surface more that the bottom since most microorganisms grow in the worm condition. Also CLEANALL HEAVY PH RANGE is neutral so most microorganism will feed it. this lead to more fast biodegradation.
ü Minimizes environmental damage.
ü Cost effective and economical.
ü Easy to handle and apply.
ü Application to mineral oils, crude oils, fuel oils, kerosene and lubricant oils, tank de-sludging cleaner and decontamination of equipment/pipelines /floor and wall .
* PHYSICAL PROPERTIES : SEE NIOF REPORT.
* EFFCIENCY :SEE NIOF REPORT, AS STRONG AS IT IS SAFE
* BIODEGRADABILITY :SEE NIOF REPORT.
* TOXICITY : SEE NIOF REPORT, FACULTY OF SIENCE-ALEXANDRY UNIVERSITY REPOTRS.
* HEAVY METAL : SEE CHEMISTRY ADMINSTRATION REPORT.
ü APPLICATION AND USE :
A. Dosing procedure:
At Sea: The quantity of CLEANALL HEAVY OIL SPILL DISPERSANT to be used depends on three main factors: the quantity of oil spilled, the type of oil spilled and the weather conditions . However, the result of NIOF suggest that each one liter of petroleum oil needs about 10 liters of dispersant of concentration 10% (Cleanall Heavy) to disperse about 90% of oil.
At Shore: The quantity of CLEANALL HEAVY OIL SPILL DISPERSANT demanded in this case, depends on the size of contamination in the affected area. Repetition of the cleaning process may be necessary, until oil–spill elimination is complete.
B. Cleaning Procedure
At Sea:
1. Determine the oil–spillage size and kind.
2. Prepare the tools necessary to apply the product,
3. Spray the required quantity of the product, with the appropriate spraying equipment, over the oil spill.
4. Wait for a few minutes until oil spill has emulsified.
5. In the case of a persistent/stubborn oil spill, repeat cleaning process until oil spill elimination is complete.
At Shore:
1. Follow steps 1, 2, 3 as described in part At Sea.
2. Let it soak for few minutes and remove from the treated area.
3. Rinse thoroughly by applying high pressure water source and collect residual.
4. Repeat cleaning of contaminated area if necessary.
On Ship:
1. Follow steps 1, 2, 3 as described in part At Sea.
2. After spraying and/or pouring, mix thoroughly using a brush, mop, sponge or any other stirring device feasible to move with rapid and irregular action.
3. Pour water over the treated surface and mix vigorously.
4. Rinse thoroughly by applying high-pressure water source.
5. Repeat cleaning if necessary
