The glass door is really a special door in our own life. It is a great door. The glass utilised in the current glass door is especially divided into tempered magnifying glaas and ordinary float glass, and generally has the thickness of 12 mm (mm). Cut from glass, it is strong with tempered glass. So it is safe. And now the glass doors are constructed with clear glass, and they have very good lighting effectiveness. Then, Xiaobian will quickly go over the knowledge of that glass door, and I hope that it'll be very helpful to most people.

Glass door installation technique

1. Positioning of the particular pay-off: The tempered insulated glass door put together with the fixed glass as well as movable glass door leaf is usually uniformly positioned for placing.

2. Limiting groove with the top of the increasing frame: The width on the limiting slot should be a lot more than 2-4mm for the a glass thickness and 10-20mm with the groove depth. When setting up, firstly pull out both the metal decorative board edges from your drawn line, and then press along side it line to install the limit slot at the top of the entrance frame.

3. Install the wooden bottom belonging to the metal veneer: first fix the square wood on the ground, then stick the metal veneer on the wood with the common glue. The square wood can be directly nailed to the actual pre-embedded wooden brick, or with the expansion bolt. The means of connection is fixed.

SOME. Install the vertical entry frame: connect the center distinct the bullet to the particular door frame, then use the plywood to determine the form and position of this door frame column, fifth wrap the metal cosmetic surface.

5. Install this glass: use a goblet suction cup machine for you to suck the thick cup, then hold the suction tumbler to lift the heavy glass plate by 2-3 folks and move it towards the installation position.

6. Permanent glass: Two small square wooden strips on the bottom and side in the wooden block are placed in the middle door, the square wood strip is approximately 4mm away from the particular glass plate surface, after which you can the universal glue is painted around the square wooden strip. The facing metal is stuck on the square strip.

7. Treatment glass seal: In the gap between the superior limit groove and the end bracket, and the gap concerning the thick glass and also the frame column, the cup seal is injected.

7. Docking between glass: When the fixed component to the glass door is required to be spliced by the oversize, the seam needs to have a width of 2-3mm, as well as edge of the glass must be chamfered.

9. Installation of moving glass door leaf: Prior to door leaf is established, the grounding spring plus the positioning pin on the superior surface of the door frame need to be positioned and installed. Both must be coaxial. Check the vertical brand during installation to ensure the center of the ground spring shaft and the positioning pin. The lines are for the same line.

10. Deploy the glass door leaf top and lower door clamps: Install top of the and lower metal door clips around the upper and lower ends of the glass door and measure the height in the door.

Today's glass doors have grown common in our life, and there are many different kinds of glass doors, such as decorative glass doors, basic safety glass doors, energy-saving magnifying glaas doors, coated glass doorways, induction glass doors, et cetera. But no matter which sort of glass door has very good noise reduction performance, windproof performance, dustproof performance and etc. Therefore, it is widely used in many industries, just like hotels, hotels, banks, place of work buildings, hospitals, shops, and so on.,and the most common is the pedal-sensing magnifying glaas door.